Display The Sp Firmware Version; Bios Post Event Messages - Oracle netra X5-2 Service Manual

Display the SP Firmware Version

"Access the SP (Oracle ILOM)" on page 28
■
Display the SP Firmware Version
1. Access Oracle ILOM.
See "Access the SP (Oracle ILOM)" on page
2. Display the SP firmware version and build time.
-> version /SP
SP firmware 3.1.0.18
SP firmware build number: 71793
SP firmware date: Sat Feb 11 02:13:30 EST 2012
SP filesystem version: 0.1.23
->
Related Information
"Enable Oracle ILOM Legacy Targets" on page 35
■
"Display Oracle ILOM Log Entries" on page 35
■
"Oracle ILOM Log Entry Filters" on page 36
■
"Display Active Power Consumption" on page 37
■
"Display Information About User Sessions" on page 38
■
"Display the NET MGT Configuration Properties" on page 39
■

BIOS POST Event Messages

During BIOS power-on self-test, these event messages might be displayed:
BIOS POST Event Message
ACPI Power state
Boot media failure
Correctable ECC
Embedded controller management
Firmware (BIOS) ROM corruption
40 Netra Server X5-2 Service Manual • October 2016
28.
Cause
User has configured a soft power-off.
No bootable media was found. BIOS was configured to boot off of removable
media, yet none is available. Alternatively, bootable media is available, but lacking
true boot capability.
A correctable ECC error was detected in memory. A memory cell has failed in a
DIMM, but was corrected.
Hardware management controller was initialized.
BIOS checksum fails although the boot block might not be corrupted. The boot
process terminates.