Enable Oracle Ilom Legacy Targets; Display Oracle Ilom Log Entries - Oracle netra X5-2 Service Manual

"Display the SP Firmware Version" on page 40
■
Related Information
"Understanding Diagnostics" on page 21
■
"Interpreting Diagnostic LEDs" on page 30
■
"BIOS POST Event Messages" on page 40
■
"Troubleshooting (Oracle ILOM /System Targets)" on page 42
■
"Displaying Faulty Components" on page 46
■
"Troubleshooting (Oracle ILOM Legacy Targets)" on page 51
■

Enable Oracle ILOM Legacy Targets

Oracle ILOM legacy targets are not available or functional until you perform this procedure.
1. Access Oracle ILOM.
See "Access the SP (Oracle ILOM)" on page
Enable the Oracle ILOM legacy targets.
2.
-> set /SP/cli legacy_targets=enabled
Set 'legacy_targets' to 'enabled'
->
3. You can now perform diagnostics with Oracle ILOM legacy targets.
See "Troubleshooting (Oracle ILOM Legacy Targets)" on page
Related Information
"Display Oracle ILOM Log Entries" on page 35
■
"Oracle ILOM Log Entry Filters" on page 36
■
"Display Active Power Consumption" on page 37
■
"Display Information About User Sessions" on page 38
■
"Display the NET MGT Configuration Properties" on page 39
■
"Display the SP Firmware Version" on page 40
■

Display Oracle ILOM Log Entries

Access Oracle ILOM.
1.
Enable Oracle ILOM Legacy Targets
28.
51.
Detecting and Managing Faults 35