Remove The Dvd Sata Cable; Netra Server X5-2 Service Manual • October - Oracle netra X5-2 Service Manual

Remove the DVD SATA Cable

"Install the Fan Tray" on page 255
■
"Install a Fan Module" on page 133
■
Install all fan modules.
5. Connect the drive power cable to the drive backplane connector.
See "System Cable Configuration" on page
6. Consider your next step.
If you installed a cable as part of a replacement operation, go to
■
If you installed a cable as part of another component's removal or installation procedure,
■
return to that procedure.
See
7. Finish the installation procedure.
See "Returning the Server to Operation" on page
Related Information
"Remove the Backplane Power Cable" on page 161
■
"Component Locations (Storage, Power, and Fan Modules)" on page 14
■
"Preparing for Service" on page 61
■
"Returning the Server to Operation" on page 247
■
Remove the DVD SATA Cable
Removing a cable is a cold-service operation. You must power off the server before you remove
the cable.
Determine which cable to remove.
1.
See "System Cable Configuration" on page
Consider your next step.
2.
If you have not prepared for service, do so now.
■
See
If you are removing a cable as part of another component's removal or installation
■
procedure, go to
3. Review this information, and complete these prerequisites in this order.
"Remove a Fan Module" on page 132
■
164 Netra Server X5-2 Service Manual • October 2016
"Component Service Task Reference" on page 65
"Preparing for Service" on page
Step 3.
156.
for assistance.
247.
156.
61.
Step 7.