Display Fruid And Fault State For Specific Components - Oracle netra X5-2 Service Manual

Display FRUID and Fault State for Specific Components

"Oracle ILOM Legacy Targets for Component FRUID and Fault States" on page 53
■
"Display Component Voltages" on page 53
■
"Display Component Power Consumption" on page 54
■
"Oracle ILOM Legacy Targets for Component Power Consumption" on page 55
■
"Display Component Temperatures" on page 55
■
"Display Component Fan Speeds" on page 56
■
"Display Component LED State" on page 57
■
"Oracle ILOM Legacy Targets for LED States" on page 57
■
Related Information
"Understanding Diagnostics" on page 21
■
"Interpreting Diagnostic LEDs" on page 30
■
"Troubleshooting (Oracle ILOM /SP Targets)" on page 34
■
"BIOS POST Event Messages" on page 40
■
"Troubleshooting (Oracle ILOM /System Targets)" on page 42
■
"Displaying Faulty Components" on page 46
■
Display FRUID and Fault State for Specific
Components
Access Oracle ILOM.
1.
See "Access the SP (Oracle ILOM)" on page
2. If you have not already done so, enable Oracle ILOM legacy targets.
See "Enable Oracle ILOM Legacy Targets" on page
3. Type.
-> show target
where target is from the table in
Fault States" on page
Related Information
"Oracle ILOM Legacy Targets for Component FRUID and Fault States" on page 53
■
"Display Component Voltages" on page 53
■
"Display Component Power Consumption" on page 54
■
"Display Component Temperatures" on page 55
■
52 Netra Server X5-2 Service Manual • October 2016
28.
"Oracle ILOM Legacy Targets for Component FRUID and
53.
35.