Config Traffic Trap - D-Link DGS-3200 SERIES Cli Manual

threshold
countdown
time_interval
Restrictions
You must have administrator privileges.
Examples
To configure traffic control and state:
D G S - 3 2 0 0 - 1 0 : 4 # c o n f i g t r a f f i c c o n t r o l 1 - 1 0 b r o a d c a s t e n a b l e a c t i o n s h u t d o w n
t h r e s h o l d
1 t i m e _ i n t e r v a l 1 0
C o m m a n d : c o n f i g t r a f f i c c o n t r o l 1 - 1 0 b r o a d c a s t e n a b l e a c t i o n s h u t d o w n t h r e s h o l d
1
1 0 t i m e _ i n t e r v a l 1 0
S u c c e s s .
D G S - 3 2 0 0 - 1 0 : 4 #

47-2 config traffic trap

Purpose
Used to configure a traffic control trap.
Format
config traffic trap [none|storm_occurred|storm_cleared|both]
Description
This command configures whethers storm control notification will be generated or not while traffic
DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
countdown, and time_interval as well.
The upper threshold at which the specified storm control will turn on.
The <value 512-1024000>is the number of broadcast/multicast
packets per second received by the switch that will trigger the storm
traffic control measure. Must be an unsigned integer.
Timer for shutdown mode. When a port enters a shutdown RX state,
and if this times out, the port will shut down the port forever. The
default is 0 minutes. 0 is the disable forever state.
The sampling interval of received packet counts. The possible
value will be 5 to 30 seconds. This parameter is meaningless for
dropping packets is selected as action.
433