Switch Port Command List; Config Ports - D-Link DGS-3200 SERIES Cli Manual

2 Switch Port Command List

config ports [ <portlist>| all ] {medium_type[fiber|copper]} { speed [auto | 10_half | 10_full | 100_half |
100_full | 1000_full{master|slave}] | flow_control [enable | disable] | learning [enable | disable ]
| state( [enable | disable ] [description <desc 1-32> | clear_description])
show ports { <portlist> } { [ description | err_disabled ]}

2-1 config ports

Purpose
Used to configure the switch port settings.
Format
config ports [ <portlist> | all ] {medium_type[fiber|copper]}{speed [auto | 10_half | 10_full |
100_half | 100_full | 1000_full {master|slave} ] | flow_control [enable | disable]
| learning [enable | disable ]| state [enable | disable ] | [description <desc 1-32> |
clear_description] }
Description
The config ports command changes switch port settings.
Parameters
Parameters
portlist
all
medium_type
Speed
DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
Description
Specified a range of ports to be configured.
For set all ports in the system, you may use "all" parameter.
Specify the medium type when configuring ports that are combo ports.
It's an optional parameter for configuring the medium type of a combo
port; If there are no combo ports, user need not specify
medium_type in the command.
You can set port speed for the specified ports .
auto
10_half
10_full
100_half
100_full
Set port speed to auto negotiation.
Set port speed to 10_half.
Set port speed to 10_full.
Set port speed to 100_half.
Set port speed to 100_full._
24