Config Jwac Radius_Protocol; Create Jwac User - D-Link DGS-3200 SERIES Cli Manual

42-14 config jwac radius_protocol

Purpose
Used to configure the RADIUS protocol used by JWAC.
Format
config jwac radius_protocol [local | pap | chap | ms_chap | ms_chapv2 | eap_md5]
Description
The config jwac radius_protocol command allows you to specify the RADIUS protocol used by JWAC to
complete RADIUS authentication.
Parameters
Parameters
local
pap
chap
ms_chap
ms_chapv2
eap_md5
Restrictions
JWAC share other RADIUS configurations with 802.1x, when using this command to set the RADIUS
protocol, you must make sure the RASIUS server added by the "config radius ..." command supports the
protocol. You must have administrator privileges.
Example
D G S - 3 2 0 0 - 1 0 : 4 # c o n f i g j w a c r a d i u s _ p r o t o c o l m s _ c h a p v 2
C o m m a n d : c o n f i g j w a c r a d i u s _ p r o t o c o l m s _ c h a p v 2
S u c c e s s .
D G S - 3 2 0 0 - 1 0 : 4 #

42-15 create jwac user

Purpose
Used to create JWAC user into local DB.
DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
Description
JWAC Switch uses local user DB to complete the authentication.
JWAC Switch uses PAP to communicate with the RADIUS Server.
JWAC Switch uses CHAP to communicate with the RADIUS Server.
JWAC Switch uses MS-CHAP to communicate with the RADIUS
Server.
JWAC Switch uses MS-CHAPv2 to communicate with the RADIUS
Server.
JWAC Switch uses EAP MD5 to communicate with the RADIUS Server.
371