Create Syslog Host - D-Link DGS-3200 SERIES Cli Manual

Example
D G S - 3 2 0 0 - 1 0 : 4 # c o n f i g s y s l o g h o s t a l l s e v e r i r y a l l f a c i l i t y l o c a l 0
C o m m a n d : c o n f i g s y s l o g h o s t a l l s e v e r i r y a l l f a c i l i t y l o c a l 0
S u c c e s s .
D G S - 3 2 0 0 - 1 0 : 4 #

8-11 create syslog host

Purpose
Used to create a new syslog host.
Format
create syslog host <index 1-4> {severity [informational|warning|all] | facility[local0|local1
|local2|local3|local4|local5|local6|local7] |udp_port <udp_port_number> | ipaddress <ipaddr>
|state [enable|disable]}
Description
The config syslog command creates a new syslog host.
Parameters
Parameters
host <index 1-4>
severity
facility
DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
Description
The host index.
Three levels are supported:
informational
warning
all
Some of the operating system daemons and processes have been
assigned Facility values. Processes and daemons that have not been
explicitly assigned a Facility may use any of the"local use" facilities or
they may use the "user-level" Facility. Those Facilities that have been
designated are shown in the following: Bold font means the facility
values the switch supports now.
local0
local1
local2
local3
local4
Informational messages.
Warning conditions.
Any condition.
user-defined Facility
user-defined Facility
user-defined Facility
user-defined Facility
user-defined Facility
101