Show Snmp Traps; Config Rmon Trap - D-Link DGS-3000 Series Reference Manual

DGS-3000 Series Layer 2 Managed Gigabit Switch CLI Reference Guide
Example
To configure the trap state for warmstart event:
DGS-3000-26TC:admin#config snmp warmstart_traps enable
Command: config snmp warmstart_traps enable
Success.
DGS-3000-26TC:admin#

69-33 show snmp traps

Description
This command is used to display the snmp trap sending status.
Format
show snmp traps {linkchange_traps {ports <portlist>}}
Parameters
linkchange_traps - (Optional) Specifies that the SNMP trap sending status will be displayed.
ports - (Optional) Specifies the ports for the display.
<portlist> - Enter the list of ports used for the display here.
Restrictions
None.
Example
DGS-3000-26TC:admin#show snmp traps
Command: show snmp traps
SNMP Traps
Authenticate Trap
Linkchange Traps
Coldstart Traps
Warmstart Traps
DGS-3000-26TC:admin#

69-34 config rmon trap

Description
This command is used to configure the trap state for RMON events.
: Enabled
: Enabled
: Enabled
: Enabled
: Enabled
622