D-Link DGS-3200 SERIES Cli Manual page 426

offset_48-63 <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff>|
offset_64-79 <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> }
| ipv6
{class <value 0-255> | flowlabel <hex 0x0-0xfffff>|
source_ipv6 <ipv6addr> | destination_ipv6 <ipv6addr>} ]
port [<portlist> | all ] [ permit | deny] {time_range <range_name 32>}
| delete access_id <value 1-100> ]
Description
The config cpu access_profile command configures CPU access list entry.
Parameters
Parameters
profile_id
access_id
DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
Description
Specifies the index of CPU access list profile.
Specifies the index of an access list entry. The range of this value is 1 to 100.
Specifies a VLAN name.
vlan
Specifies the source MAC.
source_mac
Specifies the destination MAC.
destination_m
ac
Specifies the value of 802.1p priority tag, the value can be
802.1p
configured between 1 and 7.
ethernet_type Specifies the Ethernet type.
Spcifies a VLAN name.
vlan
Specifies an IP source address.
source_ip
destination_ip Specifies an IP destination address.
Specifies the value of DSCP, the value can be configured from
dscp
0 to 63.
Specifies that the rule applies to ICMP traffic.
icmp
type
code
Specifies that the rule applies to IGMP traffic.
igmp
type
src_port Specifies that the rule applies to the range of TCP
tcp
dst_port Specifies the range of the TCP destination port range
flag
src_port Specifies the range of the TCP source port range.
udp
dst_port Specifies the range of the TCP destination port mask
Specifies the ICMP packet type.
Specifies the ICMP packet code.
Specifies the IGMP packet type.
source ports.
Specifies the TCP flag fields.
426