Disable Address_Binding Acl_Mode - D-Link DGS-3200 SERIES Cli Manual

If the ACL pool is full before creating all the address binding entries, then the address binding module can
not create access entries. The switch will show an error message and the switch will set up these address
binding entries as inactive.
Parameters
None.
Restrictions
You must have administrator privileges.
Examples
To enable the address binding ACL mode:
D G S - 3 2 0 0 - 1 0 : 4 #enable address_binding acl_mode
Command: enable address_binding acl_mode
Success.
D G S - 3 2 0 0 - 1 0 : 4 #

39-7 disable address_binding acl_mode

Purpose
To disable the address binding ACL mode.
Format
disable address_binding acl_mode
Description
User use this command to enter the address binding normal mode..
If a user disable the address binding ACL mode, the switch will delete the access profiles and access
entries which were created by address binding module.
Parameters
None.
Restrictions
You must have administrator privileges.
DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
338