D-Link DGS-3200 SERIES Cli Manual page 100

Format
config syslog host [ all |<index 1-4>] { severity [informational |warning | all ] |
facility [ local0 | local1 | local2 | local3 | local4 | local5 | local6 | local7 ] |
udp_port <udp_port_number> | ipaddress <ipaddr> | state [enable |disable ]}
Description
The config syslog command configures the syslog host configurations
Parameters
Parameters
host [all|<index 1-4>]
severity
facility
udp_port
ipaddr
state
Restrictions
You must have administrator privileges.
DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
Description
Host index or all hosts
Three level supported:
informational
warning
all
Some of the operating system daemons and processes have been
assigned Facility values. Processes and daemons that have not been
explicitly assigned a Facility may use any of the"local use" facilities or
they may use the "user-level" Facility. Those Facilities that have been
designated are shown in the following: Bold font means the facility
values the switch supports now.
local0
local1
local2
local3
local4
local5
local6
local7
The UDP port number
The IP address of the host.
The syslog protocol has been used for the transmission of event
notification messages across networks to host. This option enables or
disables the host to receive such messages.
informational messages
warning conditions
any condition
user-defined Facility
user-defined Facility
user-defined Facility
user-defined Facility
user-defined Facility
user-defined Facility
user-defined Facility
user-defined Facility
100