Show Traffic Control; Config Traffic Trap - D-Link DGS-1210/ME series Reference Manual

To configure traffic control and enable broadcast storm control system wide:
DGS-1210-28P/ME:5# config traffic control all multicast enable unicast disable
broadcast enable threshold 64
Command: config traffic control all multicast enable unicast disable broadcast e
nable threshold 64
*Note: Setting count down for drop mode port was ignored.
Success.
DGS-1210-28P/ME:5#

show traffic control

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display traffic control setting for ports 1-3:

config traffic trap

Purpose
Syntax
Description
Parameters
DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
To display current traffic control settings.
show traffic control {<portlist>}
The show traffic control command displays the current storm traffic
control configuration on the Switch.
<portlist> - A port or range of ports whose settings are to be
displayed.
None.
DGS-1210-28P/ME:5# show traffic control 1-3
Command: show traffic control 1-3
Traffic Storm Control Trap : [None]
Port Thres Broadcast Multicast Unicast Action Count
hold Storm
---- ------- -------------- ------------- ----------
1 64 Enabled
2 64 Enabled
3 64 Enabled
Total Entries : 3
DGS-1210-28P/ME:5#
To configure the traffic control trap on the Switch.
config traffic trap [storm_cleared | storm_occured | both | none]
The config traffic trap command configures the current storm traffic
trap configuration on the Switch.
storm_cleared – A notification will be generated when a storm event
Storm Storm
--------
Enabled Disabled Drop
Enabled Disabled Drop
Enabled Disabled Drop
183
Time
down Interval
-------- --------
0 0
0 0
0 0