Config Address_Binding Ip_Mac Ports - D-Link DGS-3200 SERIES Cli Manual

acl
Restrictions
You must have administrator privileges.
Examples
To create address binding on the Switch:
D G S - 3 2 0 0 - 1 0 : 4 #create address_binding ip_mac ipaddress 10.1.1.1
mac_address 00-00-00-00-00-11
Command: create address_binding ip_mac ipaddress 10.1.1.1 mac_address
00-00-00-00-00-11
Success.
D G S - 3 2 0 0 - 1 0 : 4 #

39-2 config address_binding ip_mac ports

Purpose
Used to configure an IP-MAC state to enable or disable for specified ports.
Format
config address_binding ip_mac ports [<portlist> | all] {state[enable| disable] |allow_zeroip [enable|
disable]
Description
This command will configure the IP-MAC state to enable or disable for specified ports.
Parameters
Parameters
ports
state
DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
defaults to ARP mode. If the system is in ARP mode, the ARP
mode entries and ACL mode entries will be effective. If the
system is in ACL mode, only the ACL mode entries will be
active; the ARP mode entry will not be in effect.
This entry is specified as an ACL mode entry. If a user enables
ACL mode, this entry will be added as access entry.
Description
portlist: Specifies a port or range of ports.
all: specifies all ports on the switch.
Enables or disables the specified range of ports.
333