Delete Link_Aggregation Group_Id; Config Link_Aggregation - D-Link DGS-3200 SERIES Cli Manual

22-2 delete link_aggregation group_id

Purpose
Used to delete a previously configured link aggregation group.
Format
delete link_aggregation group_id <value 1-5>
Description
The delete link_aggregation group_id command is used to delete a previously configured link
aggregation group.
Parameters
Parameters
group_id
Restrictions
You must have administrator privileges.
Example
To delete a link aggregation group:
D G S - 3 2 0 0 - 1 0 : 4 # d e l e t e l i n k _ a g g r e g a t i o n g r o u p _ i d 3
C o m m a n d : d e l e t e l i n k _ a g g r e g a t i o n g r o u p _ i d 3
S u c c e s s .
D G S - 3 2 0 0 - 1 0 : 4 #

22-3 config link_aggregation

Purpose
Used to configure a previously created link aggregation group.
Format
config link_aggregation group_id <value> {master_port <port> | ports <portlist> | state
[enabled|disabled]}
Description
The config link_aggregation command allows you to configure a link aggregation group that was created
with the create link_aggregation command above.
DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
Description
The specifies the group ID. The group number identifies each of the groups.
The switch allows up to five link aggregation groups to be configured.
192