Config Access_Profile - D-Link DGS-3200 SERIES Cli Manual

46-3 config access_profile

Purpose
Used to configure access list entry.
Format
config access_profile profile_id <value 1-200>
[ add access_id [ auto_assign | <value 1-200> ]
[ ethernet
{vlan <vlan_name 32> | source_mac <macaddr 000000000000-ffffffffffff> |
destination_mac <macaddr 000000000000-ffffffffffff> |
802.1p <value 0-7> |ethernet_type <hex 0x0-0xffff> }
| ip
{ vlan <vlan_name 32> | source_ip <ipaddr> |destination_ip <ipaddr> |dscp <value 0-63> |
[icmp {type <value 0-255>| code <value 0-255>} | igmp {type <value 0-255>} |
tcp { src_port <value 0-65535> | dst_port <value 0-65535> |
urg | ack | psh | rst | syn | fin} |
udp {src_port(<value 0-65535> | dst_port <value 0-65535>} |
protocol_id <value 0 - 255> {user_define<hex 0x0-0xffffffff>}]}
| packet_content_mask
{offset_chunk_1
offset_chunk_2 <hex 0x0-0xffffffff>
offset_chunk_3 <hex 0x0-0xffffffff>
offset_chunk_4 <hex 0x0-0xffffffff> }
| ipv6
{ class <value 0-255> | flowlabel <hex 0x0-0xfffff> |
source_ipv6 <ipv6addr> | destination_ipv6 <ipv6addr>} ] port [<portlist> | all ]
[ permit { priority <value 0-7> {replace_priority}| replace_dscp <value 0-63> | rx_rate [ no_limit |
<value 1-156249>] } | mirror | deny] {time_range <range_name 32>}
|delete access_id <value 1-200> ]
Description
The config access_profile command configures access list entry.
Note: Please see the Appendix section entitled "Mitigating ARP Spoofing Attacks Using Packet Content
ACL" for a configuration example and further information.
DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
<hex 0x0-0xffffffff>
416