Utility Command List; Download - D-Link DGS-3200 SERIES Cli Manual

4 Utility Command List

download [ firmware_fromTFTP [ <ipaddr> | <ipv6addr> ] <path_filename 64> image_id <1-2> ]
| [ cfg_fromTFTP <ipaddr> <path_filename 64> {[<config_id 1-2> | increment]} ]
upload log_toTFTP [ <ipaddr> | <ipv6addr> ] <path_filename 64> ]
upload cfg_toTFTP [ <ipaddr> | <ipv6addr> ] <path_filename 64> { <config_id 1-2>}
config firmware image_id <1-2> [delete | boot_up]
config configuration <config_id 1-2> [boot_up | delete | active]
show firmware information
show config [ current_config | config_in_nvram <config_id 1-2> | information ]
ping <ipaddr> {times <value 0-255>} {timeout <sec 1-99>}
traceroute <ipaddr> {ttl <value 1-60>} {port <value 30000-64900>} {timeout <sec 1-65535>} {probe
<value 1-9>}
telnet <ipaddr> {tcp_port <value 0-65535>}
Note: The Interface field is used for addresses on the link-local network. It is recommended that the user enter the
specific interface for a link-local IPv6 adress. The field may be omitted for global IPv6 addresses. For example,
DGS-3200-10:4#upload cfg_toTFTP fe80::20d:88ff:fe11:7b6c%System DGS-3200.cfg

4-1 download

Purpose
Used to download and install new firmware or a switch configuration file from a TFTP server.
Format
download [ firmware_fromTFTP [ <ipaddr> | <ipv6addr> ] <path_filename 64> image_id <1-2> ]
| [ cfg_fromTFTP <ipaddr> <path_filename 64> {[<config_id 1-2> | increment]} ]
Description
This command is used to download a new firmware or a switch configuration file from a TFTP server. The
firmware can be loaded to different section according to the image_id or the config_id.
DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
49