D-Link DGS-3200 SERIES Cli Manual page 380

tx_rate
Restrictions
You must have administrator privileges.
Examples
To configure the port bandwidth:
D G S - 3 2 0 0 - 1 0 : 4 # c o n f i g b a n d w i d t h _ c o n t r o l 1 - 1 0 t x _ r a t e 1 0 2 4
C o m m a n d : c o n f i g b a n d w i d t h _ c o n t r o l 1 - 1 0 t x _ r a t e 1 0 2 4
S u c c e s s .
D G S - 3 2 0 0 - 1 0 : 4 #
DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
no_limit - Indicates there is no limit on port rx bandwidth.
An integer value from 64 to 1024000 sets a maximum limit in
Kbits/sec. The specified bandwidth limit may be equaled but not
exceeded. This exact logical limit or token value is hardware
determined. The token value will always be a multiple of the bandwidth
increment specific to the chip used for the project (i.e. 32 Kbits, 64
Kbits, 128 Kbits, etc.). This token value, the actual set limit recognized
by the CPU, will be displayed when the user enters the bandwidth limit
integer.
Note: 1 Kbit = 1000 bits, 1 Gigabit = 1000*1000 Kbits.
Specifies the limitation of transmit data rate.
no_limit - Indicates there is no limit on port tx bandwidth.
An integer value from 64 to 1024000 sets a maximum limit in
Kbits/sec. The specified bandwidth limit may be equaled but not
exceeded. This exact logical limit or token value is hardware
determined. The token value will always be a multiple of the bandwidth
increment specific to the chip used for the project (i.e. 32 Kbits, 64
Kbits, 128 Kbits, etc.). This token value, the actual set limit recognized
by the CPU, will be displayed when the user enters the bandwidth limit
integer.
Note: 1 Kbit = 1000 bits, 1 Gigabit = 1000*1000 Kbits.
380