Config Dot1V_Protocol_Group Delete Protocol; Delete Dot1V_Protocol_Group - D-Link DGS-3200 SERIES Cli Manual

21-3

config dot1v_protocol_group delete protocol

Purpose
Used to delete a protocol from protocol group.
Format
config dot1v_protocol_group [group_id < id>| group_name <name> ] delete protocol
[ethernet_2| ieee802.3_snap| eee802.3_llc] < protocol_value.>
Description
To delete a protocol from a protocol group.
Parameters
Parameters
group_id
group_name
protocol_value
Restrictions
You must have administrator privileges.
21-4

delete dot1v_protocol_group

Purpose
Delete a protocol group.
Format
delete dot1v_protocol_group [group_id <id>| group_name <name>| all]
Description
This command deletes a protocol group
Parameters
DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
Description
Specifies the group ID to be deleted.
The name of the protocol group.
The protocol value is used to identify a protocol of the frame type
specified. Depending on the frame type, the octet string will have
one of the following values: The form of the input is 0x0 to 0xffff.
For 'ethernet'II, this is a 16-bit (2-octet) hex value.
Example: IPv4 is 800, IPv6 is 86dd, ARP is 806,.. and so on.
For ' IEEE802.3 SNAP ', this is this is a 16-bit (2-octet) hex value.
Example: IPv4 is 800, IPv6 is 86dd, ARP is 806,.. and so on.
For 'IEEE802.3 LLC', this is the 2-octet IEEE 802.2 Link Service
Access Point (LSAP)
188