Config Radius - D-Link DGS-3200 SERIES Cli Manual

Restrictions
You must have administrator privileges.
Examples
To delete a RADIUS server:
D G S - 3 2 0 0 - 1 0 : 4 # c o n f i g r a d i u s d e l e t e 1
C o m m a n d : c o n f i g r a d i u s d e l e t e 1
S u c c e s s .
D G S - 3 2 0 0 - 1 0 : 4 #

35-19 config radius

Purpose
Used to configure a RADIUS server.
Format
config radius <server_index 1-3> {ipaddress [<server_ip> | <ipv6addr> ] |key <passwd 32> |
auth_port <udp_port_number 1-65535> | acct_port <udp_port_number 1-65535>| timeout <int
1-255> | retransmit <int 1-255>}
Description
The config radius command configures a RADIUS server.
Parameters
Parameters
server_index
server_ip
ipv6addr
key
passwd
auth_port
acct_port
timeout <int 1-255>
retransmit <int 1-255> The count for re-transmit. The default value is 2.
DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
Description
The RADIUS server index.
The IP address of the RADIUS server.
The IPv6 address.
The IPv6 address of the RADIUS server.
The key pre-negotiated between the switch and the RADIUS server. It
is used to encrypt user's authentication data before being transmitted
over the Internet. The maximum length of the key is 32.
Specifies the UDP port number which is used to transmit RADIUS
authentication data between the switch and the RADIUS server.
Specifies the UDP port number which is used to transmit RADIUS
accounting statistics between the switch and the RADIUS server.
The time in second for waiting server reply. The default value is 5
seconds.
281