D-Link DGS-3200 SERIES Cli Manual page 56

Format
ping <ipaddr> {times <value 0-255>} {timeout <sec 1-99>}
Description
The ping command sends Internet Control Message Protocol (ICMP) echo messages to a remote IP
address. The remote IP address will then "echo" or return the message. This is used to confirm
connectivity between the switch and the remote device.
Parameters
Parameters
ipaddr
value
sec
Restrictions
You must have administrator privileges.
Example
To send ICMP echo message to "10.51.17.1" for 4 times:
D G S - 3 2 0 0 - 1 0 : 4 # p i n g 1 0 . 5 1 . 1 7 . 1 t i m e s 4
C o m m a n d : p i n g 1 0 . 5 1 . 1 7 . 1 t i m e s 4
R e p l y f r o m 1 0 . 5 1 . 1 7 . 1 , t i m e < 1 0 m s
R e p l y f r o m 1 0 . 5 1 . 1 7 . 1 , t i m e < 1 0 m s
R e p l y f r o m 1 0 . 5 1 . 1 7 . 1 , t i m e < 1 0 m s
R e p l y f r o m 1 0 . 5 1 . 1 7 . 1 , t i m e < 1 0 m s
P i n g S t a t i s t i c s f o r 1 0 . 5 1 . 1 7 . 1
P a c k e t s : S e n t = 4 , R e c e i v e d = 4 , L o s t = 0
D G S - 3 2 0 0 - 1 0 : 4 #
DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
Description
Specify the IP address of the host.
The number of individual ICMP echo messages to be sent.
A value of 0 will send an infinite ICMP echo messages. The maximum
value is 255. The default is 0.
Defines the time-out period while waiting for a response from the
remote device.
A value of 1 to 99 seconds can be specified. The default is 1 second.
56