Create Ipif - D-Link DGS-3200 SERIES Cli Manual

Restrictions
You must have administrator privileges.
Examples
To configure the System IP interface:
D G S - 3 2 0 0 - 1 0 : 4 # c o n f i g i p i f S y s t e m v l a n v 1
C o m m a n d : c o n f i g i p i f S y s t e m v l a n v 1
S u c c e s s .
D G S - 3 2 0 0 - 1 0 : 4 #

27-2 create ipif

Purpose
Used to create an IPv6 interface for IPv6 addresses.
Format
create ipif <ipif_name > {<network_address>} <vlan_name > {state [enable|disable]}
Description
This command creates an IP interface for IPv6 only.
This interface can only be configured with an IPv6 address. Because only one IPV6 interface is supported,
when the System interface already has some IPV6 addresses, executing this command will fail.
Note: The Switch only supports one IP interface for IPV6 addresses.
Parameters
Parameters
ipif_name
network_address
vlan_name
state
Restrictions
You must have administrator privileges.
Examples
To create an IP interface
DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
Description
The name of the interface.
This parameter is not supported in the current release.
The name of the VLAN corresponding to the IP interface.
The state of the IP interface.
210