Show 802.1P Default_Priority - D-Link DGS-3200 SERIES Cli Manual

Format
config 802.1p default_priority [ <portlist> | all ] <priority 0-7>
Description
The config 802.1p default_priority command allows you to specify default priority handling of untagged
packets received by the switch. The priority value entered with this command will be used to determine
which of the four hardware priority queues the packet is forwarded to.
Parameters
Parameters
portlist
all
priority
Restrictions
You must have administrator privileges.
Examples
To configure the 802.1p default priority settings on the switch:
D G S - 3 2 0 0 - 1 0 : 4 # c o n f i g 8 0 2 . 1 p d e f a u l t _ p r i o r i t y a l l 5
C o m m a n d : c o n f i g 8 0 2 . 1 p d e f a u l t _ p r i o r i t y a l l 5
S u c c e s s .
D G S - 3 2 0 0 - 1 0 : 4 #

43-10 show 802.1p default_priority

Purpose
Used to display the current default priority settings on the switch.
Format
show 802.1p default_priority { <portlist> }
DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
Description
This specifies a range of ports for which the default priority is to be
configured. That is, a range of ports for which all untagged packets
received will be assigned the priority specified below. The beginning
and end of the port list range are separated by a dash.
Specifies that the command applies to all ports on the switch.
The priority value (0 to 7) you want to assign to untagged packets
received by the switch or a range of ports on the switch.
388