Link Aggregation Command List; Create Link_Aggregation Group_Id - D-Link DGS-3200 SERIES Cli Manual

22 Link Aggregation Command List

create link_aggregation group_id <value 1-5> {type [ lacp | static ] }
delete link_aggregation group_id <value 1-5>
config link_aggregation group_id <value 1-5> {master_port <port> | ports <portlist> | state
[enable|disable]}
config link_aggregation algorithm [mac_source_dest | ip_source_dest]
show link_aggregation {group_id <value 1-5> | algorithm}

22-1 create link_aggregation group_id

Purpose
Used to create a link aggregation group on the switch.
Format
create link_aggregation group_id <value 1-5> {type [ lacp | static ] }
Description
The create link_aggregation group_id command will create a link aggregation group.
Parameters
Parameters
group_id
type
Restrictions
You must have administrator privileges.
Example
To create a link aggregation group:
D G S - 3 2 0 0 - 1 0 : 4 # c r e a t e l i n k _ a g g r e g a t i o n g r o u p _ i d 1 t y p e l a c p
C o m m a n d : c r e a t e l i n k _ a g g r e g a t i o n g r o u p _ i d 1 t y p e l a c p
S u c c e s s
D E S - 3 2 0 0 - 1 0 : 4 #
DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
Description
Specifies the group ID. The group number identifies each of the
groups. The switch allows up to five link aggregation groups to be
configured.
Specifies the group type is belong to static or LACP. If type is not
specified, the default is the static type.
191