D-Link DGS-3200 SERIES Cli Manual page 273

Description
The config 802.1x auth_parameter command configures the parameters that control the operation of the
authenticator associated with a port.
Parameters
Parameters
portlist
all
default
direction
port_control
quiet_period
tx_period
supp_timeout
server_timeout
max_req
reauth_period
enable_reauth
Restrictions
You must have administrator privileges.
DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
Description
Specifies a range of ports to be configured.
All ports.
Sets all parameter to be default value.
Sets the direction of access control .
both
in
You can force a specific port to be unconditionally authorized or
unauthorized by setting the the parameter of port_control to be
force_authorized or force_unauthorized. Besides, the controlled port will
reflect the outcome of authentication if port_control is auto.
force_authorized
auto
force_unauthorized
It is the initialization value of the quietWhile timer. The default value is 60 s
and can be any value from 0 to 65535.
It is the initialization value of the txWhen timer. The default value is 30 s
and can be any value from 1 to 65535.
The initialization value of the aWhile timer when timing out the supplicant.
Its default value is 30 s and can be any value from 1 to 65535.
The initialization value of the aWhile timer when timing out the
authentication server. Its default value is 30 and can be any value from 1 to
65535.
The maximum number of times that the authenitcation PAE state machine
will retransmit an EAP Request packet to the supplicant. Its default value is
2 and can be any number from 1 to 10.
Its a nonzero number of seconds, which is used to be the re-authentication
timer. The default value is 3600.
You can enable or disable the re-authentication mechanism for a specific
port.
For bidirectional access control.
For unidirectional access control.
273