Show Stp Ports; Config Stp Trap - D-Link DGS-1100-16/ME Reference Manual

Example usage:
To configure STP ports settings
DGS-1100-24P/ME:admin#config stp ports 5-10 edge true
Command : config stp ports 5-10 edge true
Success.
DGS-1100-24P/ME:admin#

show stp ports

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display STP ports status.
DGS-1100-24P/ME:admin#show stp ports portlist 5-8
Command : show stp ports portlist 5-8
Port Edge
------ -------- ----------
eth5 True
eth6 True
eth7 True
eth8 True
DGS-1100-24P/ME:admin#

config stp trap

Purpose
Syntax
Description
Parameters
Restrictions
DGS-1100/ME Metro Ethernet Managed Switch CLI Reference Guide
To display the edge state of each port.
show stp ports {portlist <portlist>}
The show stp ports command displays the edge mode of each
port.
portlist <portlist> – Specifies the port list to be display.
None.
State
Link down
Link down
Link down
Link down
To set the STP trap status.
config stp trap { new_root [ enable | disable ] | topo_change
[ enable | disable ] } (1)
The config stp trap command sets the STP trap status.
new_root [enable | disable] – Enable/Disable the new root traps
support.
tppo_change [enable | disable] – Enable/Disable the topology
change traps support.
Only administrator-level users can issue this command.
131