D-Link DGS-3200 SERIES Cli Manual page 410

DGS-3200 Series Layer 2 Gigabit Managed Switch CLI Manual
udp {src_port(<value 0-65535> | dst_port <value 0-65535>} |
protocol_id <value 0 - 255> {user_define<hex 0x0-0xffffffff>}]}
| packet_content_mask
{ offset_chunk_1
offset_chunk_2 <hex 0x0-0xffffffff>
offset_chunk_3 <hex 0x0-0xffffffff>
offset_chunk_4 <hex 0x0-0xffffffff> }
| ipv6 { class <value 0-255> | flowlabel <hex 0x0-0xfffff> |
source_ipv6 <ipv6addr> | destination_ipv6 <ipv6addr>} ] port [<portlist> | all ]
[ permit { priority <value 0-7> {replace_priority} | replace_dscp <value 0-63> | rx_rate
[ no_limit | <value 1-156249>] } | mirror | deny]
{time_range <range_name 32>} |delete access_id <value 1-200> ]
show access_profile {profile_id <value 1-200>}
config time_range <range_name 32> [hours start_time <time hh:mm:ss> end_time <time
hh:mm:ss> weekdays <daylist> |delete ]
show time_range
create cpu access_profile profile_id <value 1-5>
[ ethernet
{ vlan | source_mac <macmask 000000000000-ffffffffffff> |
destination_mac <macmask 000000000000-ffffffffffff> | 802.1p | ethernet_type}
| ip
{ vlan | source_ip_mask <netmask> | destination_ip_mask <netmask> |
dscp | [icmp {type | code} | igmp {type } |
tcp {src_port_mask <hex 0x0-0xffff> | dst_port_mask <hex 0x0-0xffff> |
flag_mask [ all | {urg | ack | psh | rst | syn| fin} ] } |
udp {src_port_mask <hex 0x0-0xffff> | dst_port_mask <hex 0x0-0xffff>} |
protocol_id_mask <hex 0x0-0xff> {user_define_mask <hex 0x0-0xffffffff>}]}
| packet_content_mask
{offset_0-15 <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> |
offset_16-31 <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex
0x0-0xffffffff> |
offset_32-47 <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex
0x0-0xffffffff> |
offset_48-63 <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex
0x0-0xffffffff> |
offset_64-79 <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex 0x0-0xffffffff> <hex
<hex 0x0-0xffffffff>
410