Z Fold Half Sheet Position Adjustment - Fuji Xerox ApeosPort-V C5580 Administrator's Manual

Important • Set value A and value B so that an edge of the paper does not extend beyond a fold position of the
7
Select [Adjust].
8
Select [Sample Printout] again.
9
Select the tray in which you loaded paper, and press the <Start> button.
The sample printout is printed.
10
Select [Close].
11
Confirm the result of sample printout.
12
Adjust the alignment again if necessary.
13
Select [Save].
14
Select [Close] until the Services Home screen is displayed.
Note • When you configure settings under [System Settings] or [Setup] and then press the <Services Home>

Z Fold Half Sheet Position Adjustment

1
Select [Z Fold Half Sheet - A3
Sheet - B4 ], [Z Fold Half Sheet - 11x17" ], or
[Z Fold Half Sheet - 8K
[Change Settings].
2
Select [Sample Printout].
3
Select the tray in which you loaded paper, and
press the <Start> button.
A sample printout is printed.
4
Select [Close].
5
Check the printed sample printout, and measure the A and B fold position movement
amounts.
paper. Extending an edge of paper beyond a fold position of the paper may cause a paper jam.
button, the screen directly goes back to the Services Home screen.
], [Z Fold Half
], and then select
Fold Position Adjustment
621
16