Replacing The Front Lan Connector And Board; Required Tools; Preliminary Steps - Fujitsu PRIMERGY TX140 S1 Upgrade And Maintenance Manual

Front panel and external connectors
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page
Ê Reconnect the AC power cord to the power supply unit and secure it with a
cable tie as described in section
page 90.
Ê If applicable, close the rack door as described in section
door" on page
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
BitLocker functionality" on page

13.2.3 Replacing the front LAN connector and board

Field Replaceable Units (FRU)
Average task duration: 15 minutes

13.2.3.1 Required tools

Preliminary and concluding steps: tool-less
●
Replacing the front LAN connector:
●
– Phillips PH2 / (+) No. 2 screw driver

13.2.3.2 Preliminary steps

Before replacing the front LAN connector, perform the following steps:
Ê Disable BitLocker functionality as described in section
functionality" on page
Ê If applicable, open the rack door as described in section
door" on page
Ê Locate the desired server as described in section
server" on page
408
92.
93.
61.
54.
Upgrade and Maintenance Manual
87.
"Connecting the server to the mains" on
116.
"Closing the rack
"Enabling
"Disabling BitLocker
"Opening the rack
"Locating the defective
TX140 S1