Setting Greeting And Update Prompts; Configuring Overhead Paging - Altigen ACM 6.7 Administrator's Manual

Note: You may need to reduce the music volume level 70-80% to avoid distortion.
To replace the default music-on-hold file
1. Back up the default file.
2. On the Audio Peripheral tab, uncheck the Enable Callers on Hold or in Queue
to Listen to Music or Recorded Announcement check box.
3. Rename the desired .wav file to "MusicOnWaiting.wav" and put it in the
C:\PostOffice\phrases\Music folder.
4. On the Audio Peripheral tab, check the Enable Callers on Hold or in Queue to
Listen to Music or Recorded Announcement check box.
Note: If you have two files named MusicOnWaiting in the MusicOnWaiting folder, one a
.wav file and one a PCM file, the .wav file takes precedence.
RTP Resource Usage
In the event that MAXCS is controlling multiple gateway systems, the music source can
come from the primary system or another gateway system. When a music source is in
one gateway and listeners are in another gateway, one VoIP resource channel in each
gateway is used to convey the music stream.

Setting Greeting and Update Prompts

To play a prompt before placing the caller into a hold queue:
1. Select the Play Prompt Before Placing the Caller in Queue check box.
2. Use the list to select the prompt number you want to use for the greeting message.
(Creating prompts is discussed in "Phrase Management" on page 93.)
To play an update prompt every 60 seconds:
1. Check the Play Update Prompt Every 60 Seconds check box.
2. Use the drop-down list to select the prompt number you want to use for the greeting
message.
Note:
These settings will be used by all hunt groups and workgroups as the default
system queue phrase. However, these settings will be overridden by the
workgroup's queue management phrase setting.

Configuring Overhead Paging

To configure overhead paging:
1. Connect overhead paging equipment to the audio out jack on a Triton telephony
board.
2. On the System Configuration > Audio Peripheral tab, select Enable Overhead
Paging.
Use the drop-down list to select the board to which the overhead paging is attached.
Audio Peripheral Configuration
MAXCS ACM 6.7 Administration Manual 67