Table of Contents
Advertisement
When subscribing to a SIP dial tone service, typically your service provider will provide
you with the information required in the configuration dialog box shown in Figure 58 on
page 123. Enter these service parameters to each SIP trunk channel configuration
individually.
Note:
This is signal only trunks. Make sure you have enough IP resource boards to cover
your needs.
Important:
You must add the SIP Trunk service provider's IP address to the IP Device
Range in Enterprise Manager and select the proper codec profile for this
service. See "Assigning Codec Profiles to IP Addresses" on page 322. Failure
to do this step may cause no voice path, even if the SIP Trunk channel shows
the call is connected.
Configuring a SIP Trunk
To open a trunk configuration dialog box for a SIP trunk, do one of the following:
In the Trunk Configuration window, select a SIP trunk type, click the Trunk
•
Properties button, then click the SIP Trunk Configuration button.
•
In the Board View window, double-click a SIPSP board type, click the Board
Configuration button, then click the SIP Trunk Configuration button.
Figure 58. SIP Trunk Configuration dialog box and Edit box
To edit a line, click the Edit button, fill in the blanks, and click OK.
•
SIP Server IP Address—The SIP Trunk service provider's server IP address
User Name—Assigned by the SIP Trunk service provider
•
•
Password—Assigned by the SIP Trunk service provider
•
Domain—The Domain Name of the SIP Trunk service provider, if required
MAXCS ACM 6.7 Administration Manual 123
SIP Trunk Properties
Advertisement
Table of Contents
Troubleshooting
