Altigen ACM 6.7 Administrator's Manual page 236

Configuring the AltiGen IP Phone
Figure 108. IP Phone Configuration General tab
The left side of the IP Phone Configuration window displays all the IP phone extensions
that have been set up in the system. The status "Inactive" means the Enable IP
Extension box is checked for this extension in the Extension Configuration window, but
there is no IP phone logged in to the extension. The extension may be a physical
extension using an analog phone, a MobileExt, or a virtual extension.
After creating the IP extensions, you can set the parameters on the General tab.
Note: The Apply To button works with the following parameters: General, TFTP
Server field (Reset IP Phone and Boot Download options cannot be applied to
multiple extensions), Debug, and Display Workgroup Status (IP 705 and IP
600 phones).
Parameter
General
Default
Trunk
Access
Code
222
MAXCS ACM 6.7 Administration Manual
Description
Lets you specify the IP address of the MAXCS system the IP phone is
connected to. Also see "Configuring Auto-Discovery of Server IP Address"
on page 227. The version of firmware associated with the IP phone is
automatically displayed in the Version field.
To protect the configuration on the IP phone, check the Enable
Configure Password check box and assign a numerical password.
When the user presses the Menu button on the IP phone to access the
phone configuration menu, the user will need to enter the assigned
password. You can use this check box for two purposes:
• If you publish the configuration password to the user, only the phone
user would be able to change the phone configuration.
• If you do not publish the configuration password, you can block the
phone user from changing the phone configuration.
Lets you set the digit required to enable a user to return an outside call
from the Call Log. The default trunk access code can be the route access
code, if it is set in MaxAdmin.