Using The Triton Meetme Conference Board; Configuring The Triton Analog Station Board; Configuring The Triton Analog Trunk Ls/Gs And Ls Boards; Triton Analog Station Board - Altigen ACM 6.7 Administrator's Manual

Using the Triton MeetMe Conference Board

Using the Triton MeetMe Conference Board
The Triton MeetMe conference board requires no configuration. Board resources are
available when it is installed. You do have to assign a MeetMe Conference extension
(select PBX > MeetMe Conference Configuration).
One MeetMe conference board is supported in a system.
Note: In a multiple gateways installation, the MeetMe conference board can be in any
gateway server.

Configuring the Triton Analog Station Board

Double-click the Triton Analog Station board in the Boards window to open the Board
Configuration window, similar to Figure 70 on page 140. See attribute descriptions
below Figure 70. Note the following additional information:
Double-clicking a channel in the Channel Mapping List opens a Triton Analog Line
•
configuration dialog box. See "Triton Analog Station Line Properties" on page 190.
• Clicking the Board Configuration button opens a configuration dialog box that
displays the board's serial number, DSP clock, physical and logical IDs.
Figure 71. Board Configuration dialog box
Configuring the Triton Analog Trunk LS/GS and LS
Boards
The Triton Analog Trunk board is a long form factor PCI telephony card that supports 8
or 12 trunks. The 8 port card supports only loop start (LS). The 12 port card is available
in two models; loop start/ground start (LS/GS) and LS. Both models have the same
features regarding LS. The LS/GS board is required when ground start trunks may be
required.
Double-click the board in the Boards window to open the Board Configuration
window, similar to Figure 70 on page 140. See attribute descriptions below Figure 70.
Note the following additional information:
142
MAXCS ACM 6.7 Administration Manual
This option is in the
Extension Configuration window