Altigen ACM 6.7 Administrator's Manual page 140

Triton T1/E1 Trunk Properties
Figure 59. Triton T1 Configuration dialog box
Following are the parameters for the Triton T1 Configuration dialog box.
Parameter
T1 robbed-bit signaling
Protocol
Dialing Delay
Caller ID and DID Collection
You can select the maximum time-out delays, in seconds, and the appropriate sequence
of symbols to be collected for Caller ID and DID.
Max. seconds
before the first
digit
Max. seconds
between digits
126
MAXCS ACM 6.7 Administration Manual
Description
You can set Protocol to one of the following:
• E&M Wink Start (default)
E&M Immediate Start
•
• Ground Start
• Loop Start
For signaling from one board to another, only E&M Wink Start is
supported. Loop Start, Ground Start, and E&M Immediate Start
protocols cannot be used for interfacing between two boards.
Specifies the delay, in milliseconds, after trunk seizure and before
digit dialing. This configuration will slow down the system
transmitting digits to the CO by a defined delay to avoid missing
digits. Do not change this value unless advised.
Maximum wait time before time-out for the system to identify this
digit after either the first ring in ground start or loop start or the
wink in wink start. The range is from 1-6 seconds, or None, with
a default value of 3 seconds. Do not change this value unless
advised.
None means no Caller ID or DID information will be collected. All
other options will be grayed out. Use this option to disable Caller
ID and DID collection.
Maximum wait time before time-out between two digits. Default
value is None. Do not change this value unless advised.
Selecting None means the system will only wait for the sequence
of digits that are collected within the length of time specified in the
Max. seconds before the first digit field.