Table of Contents
Advertisement
Using SNMP
Configure the parameters:
Check Enable sending SNMP traps.
•
•
Enter the SNMPv3 server address.
•
Enter the SNMPv3 server port.
•
Select a security level:
•
No Authentication and No Privacy
•
With Authentication but No Privacy
•
With Authentication and Privacy
•
Select an Authentication Method, and enter a password
•
Select a Privacy Protocol, and enter a password.
•
Configure traps:
•
Memory usage exceeds This trap is sent when MAXCS detects that the lowest
virtual memory usage exceeds a specified percentage of physical memory
configuration within a 10-minute duration. Default value is 80%. The next trap
will be sent after the condition is cleared then occurs again. The minimum
duration between any two consecutive traps is 30 minutes
Average CPU utilization exceeds This trap is sent when MAXCS detects its
•
average CPU utilization exceeds a specified percentage in any 10-minute
duration. Default value is 80%. The next trap will be sent after the condition is
cleared then occurs again. The minimum duration between any two consecutive
traps is 30 minutes
Hard disk usage exceeds This trap is sent when hard disk usage of MAXCS
•
transitioning from below threshold to on or above threshold is detected. Default
value is 80%. The minimum duration between any two consecutive traps is 30
minutes.
370
MAXCS ACM 6.7 Administration Manual
Advertisement
Table of Contents
Troubleshooting
