Setting Up Channels On The Triton T1/E1 Board; Triton T1/E1 Boards - Altigen ACM 6.7 Administrator's Manual

Important: For all back-to-back cases, the CT-Bus Clock Configuration should be set to
"Manual," and the board that is connected to the board configured as the
back-to-back clock master must be designated at the CT-Bus master.

Setting up Channels on the Triton T1/E1 Board

This section discusses setting up T1 CAS, T1 PRI, E1 CAS, or E1 PRI channels on the
Triton T1/E1 board.
Click the Protocol button in the T1 or E1 configuration dialog box (see Figure 76 on
page 146) to open the Protocol Configuration window, shown below. The Triton T1/
E1 Board can be configured to either CAS or PRI through the configuration options in the
window.
The CH -> Type list on the left side of the window displays the channel types.
Note:
In a tie-trunk configuration, set the trunks to "Out of Service" before changing the
trunk type from T1 to PRI or vice versa. Otherwise, the system will generate
garbage call records to your internal or external logger service. See "Setting
General Trunk Attributes" on page 118 for details.
Figure 77. T1 PRI Protocol Configuration dialog box (top half)
Configuring the Triton T1/E1 Board
MAXCS ACM 6.7 Administration Manual 149