Working On Dialing Patterns - Altigen ACM 6.7 Administrator's Manual

When a user makes an emergency call, the administrator wants the system to dial
•
out from local analog trunks first. If local analog trunks are busy, the system uses
the local T1 trunk.

Working on Dialing Patterns

If your system is using a route access code, most likely you have one of the following
situations:
• Your area may have multiple 10-digit dialing area codes.
• Your area may have both 10-digit and 1+10 digit dialing in a same area code.
• Your system needs to borrow another system's trunk to make an outbound call over
an IP or tie trunk.
• You would like to block a dialing pattern in addition to system restriction setting.
Dialing patterns are exceptions. If you can, minimize the number of dialing pattern
entries. Most companies don't need to create dialing patterns.
To create a dialing pattern
1. Click the Dialing Pattern tab on the Out Call Routing Configuration window.
Figure 94. Out Call Routing Configuration, Dialing Pattern tab
2. Click the Add button.
Configuring Out Call Routing
MAXCS ACM 6.7 Administration Manual 177