Table of Contents
Advertisement
CT-Bus Test Tool
PMC chip from host and DSP if T1/E1 board
•
You have the option of testing a single board or testing all boards at the same time.
CT-Bus Test Tool
The CT-Bus Test Tool is a tool that detects one-way connection, cross talk, bad MVIP
cable and static noise problems.
To run the CT-Bus Test Tool:
1. Stop AltiGen Switching Services before running this utility.
2. Launch CT-Bus Test Tool from Start > All Programs > MAXCS > Gateway Tools
> CT-Bus Test Tool.
3. Click Start to begin the test.
4. At the end of the test, the utility provides pass or fail results.
Backup and Restore Utility
Note:
The configuration backup option is turned on by default.
To back up or restore data, select either
•
From MaxAdmin: Services > Utilities > System Data Management, or
•
From the Windows Start menu: All Programs > MAXCS > Utilities > MAXCS
ACC/ACM Backup and Restore.
Figure 180. System Data Management window
Note:
The System Data Management window can only be accessed at the primary
MAXCS system; it is not available from a remote MaxAdmin client.
402
MAXCS ACM 6.7 Administration Manual
Advertisement
Table of Contents
Troubleshooting
