Ip Extension Configuration; Phone Display Options - Altigen ACM 6.7 Administrator's Manual

Parameter
Flash Duration
Ringing Frequency
(Hz)
Line Disconnect
Signal
Caller ID
Transmission
Methods
Receive from phone
(dB Gain)
Transmit to phone
(dB Gain)

IP Extension Configuration

See "Setting Up IP Extensions" on page 213 for information on configuring this section
of the Extension Configuration General tab.

Phone Display Options

For analog and IP phones, the administrator can select what information is to be
displayed.
Depending on the number of display lines on the LCD, the phone can be set up to show
two lines of specific caller information on the display.
In the Phone Display field, use the Number Line and Name Line drop-down lists to
select the caller information to display:
Caller Number
•
• Caller Name
• DNIS Number
Description
Specifies the Flash Duration time in milliseconds:
• 85-750 (default)
• 50-600
• 100-700
• 150-800
• 200-900
• 300-1000
Select the frequency in Hz that is necessary for the equipment
attached to this line: 28 (default) or 20.
The loop current break desired for answering supervision.
Range 600-1000 ms (1000 ms is default).
Specifies how Caller ID will be detected:
• CID between 1st and 2nd ring - Caller ID is received between
first and second ring. (Most common in US/Canada)
• DT-AS+CID prior to ringing - Dual Tone Alerting Signal Caller
ID is received prior to ringing.
• RP-AS+CID prior to ringing - Ring Pulse Alerting Signal
Caller ID is received prior to ringing.
Range -3 ~ +3 db
You can decrease or increase the extension phone's talk volume
with this setting. Default is 0 dB.
Range -3 ~ +3db
You can decrease or increase the extension phone's receiving
volume with this setting. The volume will be lower or higher for
the extension user. Default is 0 dB.
MAXCS ACM 6.7 Administration Manual 191
Setting up Extensions