Table of Contents
Advertisement
Figure 188. Signaling Layer
6. In the E1 Channel Configuration dialog box, configure the following fields:
•
Set Calling Party Category to—the Calling Party Category indicates the type of
calling party, (for example, operator, pay phone, priority, ordinary subscriber).
Select 1, 2 or 3 (for ordinary subscribers, refer to Table 1 on page 424). If the
subscribed line is intended for other purposes, contact your CO for the proper
value.
•
Add extra digits before caller ID—consult your CO to find out if any extra digits
are needed.
•
Incoming sequences—select check box and configure the sequence according
to Table 1 on page 424.
•
In-call signaling—configure the in-call signaling value according to Table 1 on
page 424.
The circled fields in Figure 188 represent values that depend on your country and its
corresponding trunk property.
Note:
Consult your CO to find out if caller ID digits are provided in the lines.
MAXCS ACM 6.7 Administration Manual 423
Advertisement
Table of Contents
Troubleshooting
