Service Parameters/Request Information For Pri - Altigen ACM 6.7 Administrator's Manual

DNIS, Caller ID:
• DTMF (Dual Tone Multi-Frequency)
Physical Termination:
RJ-48X or RJ-48C
•
Wire:
• 4 wires
800 Service:
• You decide
Termination Impedance:
100 ohms
•
Type of Registered Services Provided
• BN 1.544 Mbps SF without power
• DN 1.544 Mbps SF B8ZS without power
• 1KN 1.544 Mbps ANSI ESF without power
• 1SN 1.544 Mbps ANSI ESF, B8ZS without power (recommended)
Service Order Code
SOC 6.0P AS.2
T1 Channel Assignment
• Trunk Type—In, Out, or 2-Way (recommended)
Channels Assigned—24 (Enter partial channels if you wish to subscribe to both voice
•
and data service.)
Hunting—Most Idle, Least Idle, Ascend, Descend
•
• DNIS Digits/Signal—3/DTMF (can be 3 to 10 digits)
Caller ID Signal—DTMF, if available (Not every service provider provides Caller ID
•
over T1 lines.)
CSU/DSU Requirements
The CSU (channel service unit) is a device used to connect a digital trunk line coming in
from the phone company to the PBX. A CSU can terminate signals, repeat signals and
respond to loopback commands sent from the central office.

Service Parameters/Request Information for PRI

To subscribe to PRI service, certain parameters are required to establish service. The
information provided below identifies the recommended and supported parameters for
PRI service. When ordering PRI service, provide the following service request
information:
Equipment Information
• PBX Manufacturer—AltiGen Communications, Inc.
CSU/DSU—ADTRAN T1 ACE (recommended) or other CSU/DSU
•
436
MAXCS ACM 6.7 Administration Manual