Table of Contents
Advertisement
The fields in this dialog box are described in the following table.
Field
SIP Protocol Field
Carrier can accept
any number
Carrier can only
accept Calling
Number with
minimum x digits
Carrier can only
accept assigned
numbers as Calling
Number
Send Caller Name
Enable Standard
Record-Route Header
Incoming DID
Number Field
Triton T1/E1 Trunk Properties
To open a configuration dialog box for a Triton T1/E1 channel, do one of the following:
•
If you're in the Trunk Configuration window, select a Triton T1/E1 channel from
the trunk channels list, then click the Trunk Properties button, or just double-click
the channel in the list.
•
If you're in the Trunk View window, right-click the channel and select Channel
Properties.
Description
Not Sent (default)—Do not send transmitted caller ID
FROM Header—Send the caller ID using the SIP FROM
header
P-Preferred Identity—Send the caller ID using the SIP
P-Preferred Identity header
P-Asserted Identity—Send the caller ID using the SIP
P-Asserted Identity header
This is the default.
Enter the number of digits, then enter a calling number in the
field below the table in case the carrier cannot accept
configured numbers.
If you select the this option, specify "assigned numbers" by
clicking the Add button and entering the numbers. To edit or
delete a number you added, select it and click the Edit or Del
button. Enter a calling number in the field below the table in
case the carrier cannot accept configured numbers.
Check to also send the caller name to callees.
Check this box if the SIP service provider uses SIP Record-
Route and the SIP trunk cannot make or receive calls. If it
already works, DO NOT CHECK or UNCHECK this box. [Service
provider Bandwidth.com with Edgewater Route require this
checked]
When a call comes in, the SIP trunk uses To Header or
Request URI as the DID/DNIS number
MAXCS ACM 6.7 Administration Manual 125
Triton T1/E1 Trunk Properties
Advertisement
Table of Contents
Troubleshooting
