Table of Contents
Advertisement
After you configure the UM mailbox to use a dialing rule group, the dialing
restrictions that are configured apply to all UM-enabled users who are associated
with the UM mailbox policy. For example, you can configure a dialing rule group that
does not require users who are associated with the dial plan to dial an outside line
access code when they place a call to an in-country/region telephone number.
Note:
If you need help in configuring dialing rules, see http://technet.microsoft.com/
en-us/library/bb629580.aspx. That will put you in the general location of what
you need. Much of this information came from that Microsoft site.
Configuring in MaxAdmin
Complete the configuration in MaxAdmin:
1. Go to System > System Configuration > Number Plan tab. In the First Digit
Assignment panel, assign one of the digits (for example, digit 8) to IP Trunk Access.
2. Go to the Trunk Configuration screen, and assign the digit selected in step 1 to all
the SIP-Tie entries. (Click the first SIP-Tie entry, and assign the digit, then use the
Apply button to apply the assignment to all the other SIP-Tie entries.) This allows
calls in either bridged or native mode to access the Exchange Server.
3. Go to VoIP > Enterprise Network Management to open Enterprise Manager.
4. Click the Codec button to create a new codec profile only for the Exchange
connection.
Figure 176. Creating a codec profile specifically for Exchange UM
a.
In the Name field, enter a name for the new codec profile.
b.
In the Codec field, select G.711 Mu-Law.
c.
In the DTMF Delivery field, select RFC2833
Configuring for Out Calling from UM
MAXCS ACM 6.7 Administration Manual 387
Advertisement
Table of Contents
Troubleshooting
