Mac-Address-Table Dynamic Group Protocols - Cisco Catalyst 4500 Series Command Reference Manual

Cisco ios command reference release ios xe 3.4.0sg and ios 15.1(2)sg
Hide thumbs Also See for Catalyst 4500 Series:
Table of Contents

Advertisement

mac-address-table dynamic group protocols

mac-address-table dynamic group protocols
To enable the learning of MAC addresses in both the "ip" and "other" protocol buckets, even though the
incoming packet may belong to only one of the protocol buckets, use the
mac-address-table dynamic group protocols command. To disable grouped learning, use the no form
of this command.
Syntax Description
ip
other
Defaults
The group learning feature is disabled.
Command Modes
Global configuration mode
Command History
Release
12.2(18)EW
Usage Guidelines
The entries within the "ip" and "other" protocol buckets are created according to the protocol of the
incoming traffic.
When you use the mac-address-table dynamic group protocols command, an incoming MAC address
that might belong to either the "ip" or the "other" protocol bucket, is learned on both protocol buckets.
Therefore, any traffic destined to this MAC address and belonging to any of the protocol buckets is
unicasted to that MAC address, rather than flooded. This reduces the unicast Layer 2 flooding that might
be caused if the incoming traffic from a host belongs to a different protocol bucket than the traffic that
is destined to the sending host.
Examples
This example shows that the MAC addresses are initially assigned to either the "ip" or the "other"
protocol bucket:
Switch# show mac-address-table dynamic
Unicast Entries
vlan
-------+---------------+--------+---------------------+--------------------
1
1
1
1
1
1
1
1
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
2-416
mac-address-table dynamic group protocols {ip | other} {ip | other}
no mac-address-table dynamic group protocols {ip | other} {ip | other}
Specifies the "ip" protocol bucket.
Specifies the "other" protocol bucket.
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
mac address
type
0000.0000.5000
dynamic other
0001.0234.6616
dynamic ip
0003.3178.ec0a
dynamic assigned
0003.4700.24c3
dynamic ip
0003.4716.f475
dynamic ip
0003.4748.75c5
dynamic ip
0003.47f0.d6a3
dynamic ip
0003.47f6.a91a
dynamic ip
Chapter 2
Cisco IOS Commands for the Catalyst 4500 Series Switches
protocols
GigabitEthernet1/1
GigabitEthernet3/1
GigabitEthernet3/1
GigabitEthernet3/1
GigabitEthernet3/1
GigabitEthernet3/1
GigabitEthernet3/1
GigabitEthernet3/1
port
OL-27596 -01

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents