Show Power - Cisco Catalyst 4500 Series Command Reference Manual

Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches

show power

To display information about the power status, use the show power command.
Syntax Description available
capabilities
detail
inline
interface detail
consumption default
module mod default
status
supplies
Defaults This command has no default settings.
Command Modes Privileged EXEC mode
Command History Release
12.1(8a)EW
12.2(25)SG
12.2(52)SG
Usage Guidelines
If a powered device is connected to an interface with external power, the switch does not recognize the
powered device. The Device column in the output of the show power inline command displays as
unknown.
If your port is not capable of supporting PoE, you will receive this message:
Power over Ethernet not supported on interface Admin
The show power inline interface | module command displays the amount of power that is used to operate
a Cisco IP Phone. To view the amount of power requested, use the show cdp neighbors command.
Because FPGAs and other hardware components on the WS-X4548-RJ45V+ and WS-X4648-RJ45V+E
modules consume PoE, the operating PoE consumption for an 802.3af-compliant module can be nonzero
when there are no powered devices attached to the module. The operating PoE can vary by as much as
20 W because of fluctuations in the PoE that is consumed by the hardware components.
OL-27596 -01
show power [available | capabilities | detail | inline {[interface] detail | consumption default |
module mod detail}} | module | status | supplies]
(Optional) Displays the available system power.
(Optional) Displays the individual power supply capabilities.
(Optional) Displays detailed information on power resources.
(Optional) Displays the PoE status.
(Optional) Detailed information on the PoE status for the interface
(Optional) Displays the PoE consumption.
(Optional) Displays the PoE consumption for the specified module.
(Optional) Displays the power supply status.
(Optional) Displays the number of power supplies needed by the system.
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Displays inline power handling for the Supervisor Engine II-Plus-TS.
Support to display detailed PoE consumption information on an interface/module.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
show power
2-891