Show Netflow-Lite Monitor - Cisco Catalyst 4500 Series Command Reference Manual

show netflow-lite monitor

show netflow-lite monitor
NetFlow-lite is only supported on the Catalyst 4948E and Catalyst 4948E-F Ethernet switches.
Note
To display information about a particular packet or per data source stats, use the show netflow-lite
monitor command.
Syntax Description
monitor-number
interface-name
vlan-id
Defaults None
Command Modes
Privileged EXEC mode
Command History Release
15.0(2)SG
Usage Guidelines
This command displays information about a particular packet or per data source stats. The interface can
be either a physical port or a VLAN.
This command displays the following packet sampling statistics:
•
•
•
The packetsObserved statistic accounts for packets that are dropped by input ACL or QoS policer.
The exported packets only represent samples from the non-dropped packet population.
Examples These examples show how to display information about a particular packet or per data source stats:
Switch# show netflow-lite monitor 1 interface gi1/3
Interface GigabitEthernet1/3:
Netflow-lite
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
2-866
show netflow-lite monitor monitor-number interface interface-name
show netflow-lite monitor monitor-number vlan vlan-id
Specifies a monitor name.
Specifies an interface.
Specifies a VLAN.
Modification
Command introduced on the Catalyst 4500 series switch.
Total # of packet (samples) exported
Total # of packet (samples) dropped due to lack of local resources
Total# of packets seen at the data source
Monitor-1:
Active: TRUE
Sampler: sampler1
Exporter: exporter1
Average Packet Size: 0
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
OL-27596 -01