Show Issu Message - Cisco Catalyst 4500 Series Command Reference Manual

Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches

show issu message

To display checkpoint messages for a specified ISSU client, use the show issu message command.
Syntax Description
groups
types
client_id
Defaults If client ID is not specified, displays message groups or message types information for all clients
registered to the ISSU infrastructure.
Command Modes User EXEC mode
Command History Release
12.2(31)SGA
Usage Guidelines Messages are sync-data (also known as checkpoint data) sent between two endpoints.
When an ISSU-aware client establishes its session with a peer, an ISSU negotiation takes place. The
ISSU infrastructure uses the registered information to negotiate the capabilities and the message version
to be used during the session.
Examples The following example shows how to display the message groups for Client_id 2082:
Switch#show issu message groups 2082
Client_ID = 2082,
Switch#
The following example shows how to display the message types for Client_id 2082:
Switch#show issu message types 2082
Client_ID = 2082,
Switch#
OL-27596 -01
show issu message {groups | types} [client_id]
Displays information on Message Group supported by the specified client.
Displays information on all Message Types supported by the specified client.
(Optional) Specifies a client ID.
Modification
This command was introduced on the Catalyst 4500 series switch.
Entity_ID = 1 :
Message_Group = 1 :
Message_Type = 1,
Message_Type = 2,
Entity_ID = 1 :
Message_Type = 1, Version_Range = 1 ~ 2
Message_Ver = 1,
Message_Ver = 2,
Message_Type = 2, Version_Range = 1 ~ 2
Message_Ver = 1,
Message_Ver = 2,
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
Version_Range = 1 ~ 2
Version_Range = 1 ~ 2
Message_Mtu = 12
Message_Mtu = 8
Message_Mtu = 32
Message_Mtu = 28
show issu message
2-799