Errdisable Recovery - Cisco Catalyst 4500 Series Command Reference Manual

Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches

errdisable recovery

To configure the recovery mechanism variables, use the errdisable recovery command. To return to the
default setting, use the no form of this command.
Syntax Description
cause
all
arp-inspection
bpduguard
channel-misconfig
dhcp-rate-limit
dtp-flap
gbic-invalid
l2ptguard
link-flap
pagp-flap
pesecure-violation
security-violation
storm-control
udld
unicastflood
vmps
arp-inspection
interval interval
OL-27596 -01
errdisable recovery [cause {all | arp-inspection | bpduguard | channel-misconfig |
dhcp-rate-limit | dtp-flap | gbic-invalid | l2ptguard | link-flap | pagp-flap |
pesecure-violation | security-violation | storm-control | udld | unicastflood | vmps}
[arp-inspection] [interval {interval}]]
no errdisable recovery [cause {all | arp-inspection | bpduguard | channel-misconfig |
dhcp-rate-limit | dtp-flap | gbic-invalid | l2ptguard | link-flap | pagp-flap |
pesecure-violation | security-violation | storm-control | udld | unicastflood | vmps}
[arp-inspection] [interval {interval}]]
(Optional) Enables the error-disable recovery to recover from a specific cause.
(Optional) Enables the recovery timers for all error-disable causes.
(Optional) Enables the recovery timer for the ARP inspection cause.
(Optional) Enables the recovery timer for the BPDU guard error-disable
cause.
(Optional) Enables the recovery timer for the channel-misconfig error-disable
cause.
(Optional) Enables the recovery timer for the DHCP rate limit error-disable
cause.
(Optional) Enables the recovery timer for the DTP flap error-disable cause.
(Optional) Enables the recovery timer for the GBIC invalid error-disable
cause.
(Optional) Enables the recovery timer for the Layer 2 protocol-tunnel
error-disable cause.
(Optional) Enables the recovery timer for the link flap error-disable cause.
(Optional) Enables the recovery timer for the PAgP flap error-disable cause.
(Optional) Enables the recovery timer for the pesecure violation error-disable
cause.
(Optional) Enables the automatic recovery of ports disabled due to 802.1X
security violations.
(Optional) Enables the timer to recover from storm-control error-disable state.
(Optional) Enables the recovery timer for the UDLD error-disable cause.
(Optional) Enables the recovery timer for the unicast flood error-disable
cause.
(Optional) Enables the recovery timer for the VMPS error-disable cause.
(Optional) Enables the ARP inspection cause and recovery timeout.
(Optional) Specifies the time to recover from a specified error-disable cause;
valid values are from 30 to 86400 seconds.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
errdisable recovery
2-257