Cisco Catalyst 4500 Series Command Reference Manual page 112

auto qos srnd4
B. This template for egress queue classes (along with the SRND4 output policy) allocates eight queues.
This template is required by all SRND4 commands:
class-map match-all AutoQos-4.0-Priority-Queue
class-map match-all AutoQos-4.0-Control-Mgmt-Queue
class-map match-all AutoQos-4.0-Multimedia-Conf-Queue
class-map match-all AutoQos-4.0-Multimedia-Stream-Queue
class-map match-all AutoQos-4.0-Trans-Data-Queue
class-map match-all AutoQos-4.0-Bulk-Data-Queue
class-map match-any AutoQos-4.0-Scavenger-Queue
Because the police commands executed in policy map configuration mode do not allow the re-marking
of qos-groups for traffic flows that exceed defined rate limits, you should configure
AutoQos-4.0-Scavenger-Queue to match either qos-group 7 or dscp af11. When you enter the auto qos
classify police command, traffic flows that violate the defined rate limit are remarked to cs1 but retain
their original qos-group classificatio because such groups cannot be re-marked as an exceed action.
However, because AutoQos-4.0-Scavenger-Queue is defined before all other queues in the output policy
map, re-marked packets fall into it, despite retaining their original qos-group labels.
class AutoQos-4.0-Scavenger-Queue
class AutoQos-4.0-Priority-Queue
class AutoQos-4.0-Control-Mgmt-Queue
class AutoQos-4.0-Multimedia-Conf-Queue
class AutoQos-4.0-Multimedia-Stream-Queue
class AutoQos-4.0-Trans-Data-Queue
class AutoQos-4.0-Bulk-Data-Queue
class class-default
—Interface Level Commands Generated
For Fa/Gig Ports:
If Layer 2 interface:
Switch(config-if)# no service-policy input AutoQos-VoIP-Input-Cos-Policy
If Layer 3 interface:
Switch(config-if)# no service-policy input AutoQos-VoIP-Input-Dscp-Policy
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
2-54
match qos-group 32
match qos-group 16
match qos-group 34
match qos-group 26
match qos-group 18
match qos-group 10
match qos-group 8
match dscp cs1
policy-map AutoQos-4.0-Output-Policy
bandwidth remaining percent 1
priority
police cir percent 30 bc 33 ms
conform-action transmit exceed-action drop
bandwidth remaining percent 10
bandwidth remaining percent 10
bandwidth remaining percent 10
bandwidth remaining percent 10
dbl
bandwidth remaining percent 4
dbl
bandwidth remaining percent 25
dbl
no service-policy output AutoQos-VoIP-Output-Policy
service-policy input AutoQos-4.0-Input-Policy
service-policy output AutoQos-4.0-Output-Policy
no service-policy output AutoQos-VoIP-Output-Policy
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
OL-27596 -01