Show Mac-Address-Table Static - Cisco Catalyst 4500 Series Command Reference Manual

Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches

show mac-address-table static

To display the static MAC address table entries only, use the show mac-address-table static command.
Syntax Description address mac_addr
interface type number
protocol protocol
vlan vlan_id
Defaults
This command has no default settings.
Command Modes
Privileged EXEC mode
Command History Release
12.1(8a)EW
12.1(12c)EW
12.2(25)EW
Usage Guidelines For the MAC address table entries that are used by the routed ports, the routed port name is displayed in
the "vlan" column not the internal VLAN number.
The keyword definitions for the protocol argument are as follows:
•
•
•
•
OL-27596 -01
show mac-address-table static [address mac_addr | interface type number | protocol protocol |
vlan vlan_id]
(Optional) Specifies a 48-bit MAC address to match; the valid format is
H.H.H.
(Optional) Specifies an interface to match; valid values for type are
fastethernet, gigabitethernet, and tengigabitethernet.
(Optional) Specifies a protocol. See the "Usage Guidelines" section for
more information.
(Optional) Displays the entries for a specific VLAN; valid values are from
1 to 4094.
Modification
Support for this command was introduced on the Catalyst 4500 series switch.
Added support for extended VLAN addresses.
Added support for the 10-Gigabit Ethernet interface.
assigned specifies the assigned protocol entries.
ip specifies the IP protocol.
ipx specifies the IPX protocols.
other specifies the other protocol entries.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
show mac-address-table static
2-839